Friday, November 09, 2018
Nitriding is a heat-treating process that’s often used on steel to make it significantly stronger. It’s done by heating a piece of steel up in a furnace and then injecting ammonia into the mix, which results in nitrogen atoms dissolving over...
Read more
Tuesday, October 16, 2018
We use graphite electrodes to EDM shapes into steel. Electrical discharge machining (EDM) is a manufacturing process where a desired shape is obtained by using electrical discharges (sparks). Material is removed from the work piece by a series of rapidly recurring current discharges between two...
Read more
Tuesday, October 16, 2018
We machined a new Split Nuts with a buttress thread for a customer’s press in these photos. A split nut is a nut that is split lengthwise into two pieces. This allows the nut, when open, to move along the screw without the screw turning...
Read more
Wednesday, October 10, 2018
Reverse engineering is a process that involves taking an existing part and figuring out exactly how it was made for the purpose of either duplicating it or finding ways in which to make it better. There are many advantages to using reverse engineering when producing...
Read more
Friday, September 28, 2018
There are numerous processes to choose from when machining parts. One of the most effective and accurate methods is called sinker EDM or electrical discharge machining. It relies on the use of an electrically charged electrode that is configured with a specific...
Read more
Thursday, September 27, 2018
In early 2015, we wrote a small blog piece on the impacts the Texas machining business was experiencing due to plummeting oil prices. Subsequently there were thousands of oil workers laid off and many industries took hits with some of them even going out of...
Read more
Thursday, September 27, 2018
This is a plastic injection mold in process at our shop and this particular mold makes a ‘male cleat’. Lowrance Machine (a moldmaker) primarily sells products to companies that are in the rubber and plastics industries. ...
Read more
Wednesday, September 12, 2018
When you start a business, one of the first things you should do is put quality management system standards into place. These standards can clearly identify your business objectives and make sure you have the right processes in place to offer high-quality...
Read more
Friday, August 10, 2018
We recently completed a 16 cavity mold for an oil industry customer. This multi-cavity mold will produce a Frac Plug which delivers speed, durability, and cost-efficiency in one tight package. The plug's shorter length makes it a formidable competitor and the slip design reduces the...
Read more
Friday, July 20, 2018
We recently completed several new wiper seal molds which are installed in the sealing configurations of hydraulic cylinders to prevent contaminants such as dirt, dust and moisture from entering the cylinder as they retract back into the...
Read more